Skip Navigation
Depleted UF6 Logo (Go to Home Page)

DUF6 GuideDUF6 Guide
 Overview Presentation
 Uranium and Its Compounds
 Depleted Uranium
 Uranium Hexafluoride
 Production and Handling
 DUF6 Health Risks
 DUF6 Environmental Risks
 DUF6 Videos
 Uranium Quick Facts
DUF6 Guide DU Uses DUF6 Management and Uses DUF6 Conversion EIS Documents  News FAQs Internet Resources Glossary

If a Cylinder Leaks

If a cylinder leak (breach) occurs and the depleted UF6 is exposed to water vapor in the air, uranyl fluoride (UO2F2) and hydrogen fluoride (HF) are formed. The uranyl fluoride is a solid that plugs the leak, limiting further escape of depleted UF6. Release of the hydrogen fluoride gas to the atmosphere is also slowed by the plug formation.

Cylinder Leak

Eight depleted UF6 cylinders have been breached (mainly from cylinder wall cracks) over the past 40 years: five of the breaches were due to corrosion around dents caused by mishandling, one breach was due to corrosion around a welding defect, and two apparently were from external corrosion. After the breaches were discovered, the material that leaked onto the ground was removed, and the cylinders were repaired. The cylinder yard workers and the environment around the cylinder yards are constantly monitored for potential radiation and chemical exposures and appropriate actions are taken if higher-than-expected readings are obtained from monitoring equipment.

When a valve leak is detected, the valve is replaced. When cylinder wall corrosion or leakage is detected, the cylinder is repaired with a patch, followed by a welded steel repair.

Patched Cylinder
Next Screen Health and Safety Risks